Hotpoint Washer Parts

Find Your Part

Model number locator Need help finding your model number?
  • Search your model number to find:
  • Genuine OEM parts guaranteed to fit
  • Free manuals and guides
  • Repair instructions and videos
Hotpoint Appliance Parts
Shop By Appliance Type Shop By Part Type

Popular Hotpoint Washer Parts

CLUTCH – Part Number: WH05X24185
Your Price
$8.54
   In Stock
Hotpoint Washer CLUTCH
★★★★★
★★★★★
1 Review
PartSelect Number PS11729473
Manufacturer Part Number WH05X24185
Fixes these symptoms
  • Noisy and Marks Left on Clothes
  • Spinning Issues
  • Will not agitate
  • See more...
Installation Instructions
Marvin from SHOSHONE, ID
Washer not spinning
Tilt washer back.
Remove belt gaurd.
Remove belt.
Remove pulley.
Remove clutch and shifter.
Install in reverse order Read more...
Pump Drain Assembly – Part Number: WH23X28418
Your Price
$48.21
   In Stock
Hotpoint Washer Pump Drain Assembly
★★★★★
★★★★★
71 Reviews
PartSelect Number PS12723115
Manufacturer Part Number WH23X28418
This drain pump assembly is for washers. Drain pump assembly removes water from the washer during the drain portion of the cycle. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included.
Fixes these symptoms
Installation Instructions
Mike from NAPLES, FL
Washer ran fine but woudl not drain water - low humming noise
Drain all the water out of the tub with a shop vac
Remove rear drain hose and drained rest of water into a bucket
Remove small rear panel (bottom left hand corner) where the drain hose connects
Tipped washer up about 45 degrees to get underneath it - Supported it with a few paint cans
Remove internal drain hose/clamps from pump - w/ pliers
Remove belt cover (gray plastic) with socket - 3 bolts
Remove wire assembly plug from socket
Remove old drain pump with socket - 3 bolts
Install new drain pump - 3 bolts - plug wire assembly into socket
Reinstall belt cover - 3 bolts
Reinstall hose to drain pump (note panel will be inside washer)
Feed drain hose panel through hole and reinstall - 1 nut
Re attached drain hose to exterior drain plug
You are done ! Read more...
MODE SHIFTER – Part Number: WH03X30517
Your Price
$39.40
   In Stock
Hotpoint Washer MODE SHIFTER
★★★★★
★★★★★
4 Reviews
PartSelect Number PS16554752
Manufacturer Part Number WH03X30517
Fixes these symptoms
  • Noisy and Marks Left on Clothes
  • Spinning Issues
  • Will not agitate
  • See more...
Installation Instructions
Marvin from SHOSHONE, ID
Washer not spinning
Tilt washer back.
Remove belt gaurd.
Remove belt.
Remove pulley.
Remove clutch and shifter.
Install in reverse order Read more...
Videos!
Tub Dampening Strap – Part Number: WH1X2727
Your Price
$9.61
   In Stock
Hotpoint Washer Tub Dampening Strap
★★★★★
★★★★★
35 Reviews
PartSelect Number PS271100
Manufacturer Part Number WH1X2727
The tub dampening straps support the wash tub and reduce vibration by keeping the tub at the center of the cabinet. If your washer shakes and moves, or is making a loud banging noise during the wash cycle, the washing machine tub could be off-balance, meaning one or more of these straps may be loose, or broken. Other symptoms include: the washer leaking, not agitating, or pumping but not spinning. These straps are sold individually. However, we recommend that you replace all 4 straps at the same time. It is also recommended that you check the tub for cracks where these straps mount.
Fixes these symptoms
Installation Instructions
molly from laguna niguel, CA
broken dampening strap and loose agitator
first remove the front washer cover by finding the two pressure clips that hold it to the top lid. gently push the putty knife into the clips one at a time. this will raise and separate them from the front panel. the panel will tilt forward and u can now remove it from the bottom clips by sliding it up and out. to open the top cover u remove the two 1/4 in screws on the sides of the front panel and lift the top. make sure to secure it in place or unplug the single electrical connection at the rear and remove the whole top from the clips, its really simple and the most convenient mehtod. to remove the straps u can now get to all four without much interference. there are two size screw heads so make sure u have a nut driver or small socket set. after changing the straps i went to change the agitator coupling. the agitator pulled directly up without a problem. just put your two hands under and pull straight up with one good jolt. the plastic coupler has one bolt in the middle that came out easily with a small socket set. my problem arose when the plastic coupler would not come off the metal shaft. after a short time of pulling and prying i finally decided to cut it off. using a small hacksaw and taking my time i put two cuts into the coupler. they were on opposite sides and where vertical, running along the steel shaft. i could now split it in two and it came off very easily and quickly. now when putting on the new one make sure the splines line up. push as far down as u can then use the center bolt to seat the gear all the way down. the agitator also has to be lined up just right. it also has splines on the interior that allow it to line up with the coupler and merely push down until it reseats itself in place. replace the top of the washer and then the front panel. don't forget to rebolt the top panel to the frame. push the front panel in until it snaps into place. full replacement time was about 40 minutes and actually not bad with the right tools. Read more...
Lid Switch Assembly – Part Number: WH08X32697
Your Price
$83.87
   In Stock
Hotpoint Washer Lid Switch Assembly
★★★★★
★★★★★
84 Reviews
PartSelect Number PS16554755
Manufacturer Part Number WH08X32697
This lid lock, also known as a door lock, is a genuine OEM replacement part for your washing machine. The lid lock keeps your washer lid closed during the washing cycle. If this part is broken, your washer may not run because it thinks the door is open, or it will not keep the door locked during the wash cycle. To replace this part, make sure you disconnect power to the appliance and wear work gloves.
Fixes these symptoms
  • Lid or door won’t close
  • Locking Issues
  • Will not agitate
  • See more...
Installation Instructions
Wiley from Wilson, NC
Wife pull up door when it was in lock mode
Lift up door removed lid lock with screwdriver installed new part Read more...
SPEED SENSOR – Part Number: WH03X32158
Your Price
$11.71
   In Stock
Hotpoint Washer SPEED SENSOR
★★★★★
★★★★★
10 Reviews
PartSelect Number PS16619248
Manufacturer Part Number WH03X32158
Fixes these symptoms
Installation Instructions
william from MARIETTA, GA
Washer not spining
Put washer on it side. Removed shield belt and pulley from motor.
Unplugged and unsnapped speed sensor and replaced with new one . Washer spinning like it should. Problem solved Read more...
SPRING CLUTCH – Part Number: WH01X24434
Your Price
$8.54
   In Stock
Hotpoint Washer SPRING CLUTCH
PartSelect Number PS11763251
Manufacturer Part Number WH01X24434
Fixes these symptoms
  • Noisy and Marks Left on Clothes
  • Spinning Issues
  • Will not agitate
  • See more...
Installation Instructions
Jose E from Mission, TX
Grinding noise LIke Gears that are not setting correctly.Disc
Disconnect power,turn off water,disconnect hose hot and cold. Disconnect drain hose careful water may drain out after you disconnect. Move washer to a place where you have enough room to work.Now lean washer to the floor on its back side Make sure to hold the lid from falling back I secure the lid with tape so it would not open. The washer should on its back side , you should see a gray wheel with a nut.Remove nut and pull the gray wheel off. you feel a magnetic pull, Once removed, you will see 3 screws remove stator now remove all screws holding the speed senors remove Mode shifter hold the Clutch because the spring is under it. Once you start it easy to replace. install new parts. Read more...
Water Inlet Valve Assembly – Part Number: WH13X26534
Your Price
$37.91
   In Stock
Hotpoint Washer Water Inlet Valve Assembly
★★★★★
★★★★★
19 Reviews
PartSelect Number PS12726768
Manufacturer Part Number WH13X26534
Fixes these symptoms
Installation Instructions
Donald from GLADE HILL, VA
Water would not stop running in to tub even when unplugged.
Removed the two 1/4" hex screws (one on each side of the control panel). Lifted the control panel off and let it hang behind the washer. Removed the connector on each side of the valve assembly. Removed the two 1/4" hex screws on the valve assembly and lifted the assembly out. Reversed the process to install. Read more...
Agitator – Part Number: WH43X30957
Your Price
$82.95
   In Stock
Hotpoint Washer Agitator
★★★★★
★★★★★
21 Reviews
PartSelect Number PS16542670
Manufacturer Part Number WH43X30957
Fixes these symptoms
Installation Instructions
MICHAEL from LK PEEKSKILL, NY
Agitator wore out over time and needed to be replaced
Replacing was easier than opening the box it came in. Used a 7/16 socket and a few extensions to reach the bottom of the agitator. It came out super quick cleaned out the fabric softener older than my kids from under it. Lined up the groves of the new one and it slid easily. I took a small piece of painters tape and crumbled it into a small ball and put it in the socket to keep the bolt in place while it lowered it into the agitator. Made it snug and we were back in business good as new!!! Read more...
WASHING MACHINE ROD & SPRING-LEFT-BLUE – Part Number: WH16X26909
Your Price
$13.79
   In Stock
Hotpoint Washer WASHING MACHINE ROD & SPRING-LEFT-BLUE
★★★★★
★★★★★
2 Reviews
PartSelect Number PS12343379
Manufacturer Part Number WH16X26909
Fixes these symptoms
Installation Instructions
chris from SHELBY, AL
Machine was noisy and banging during spin cycle
Watched the part select instructional video on YouTube. Repair was very easy. Appliance repair man quoted me $335 for this repair. I did it myself for a fraction of the cost. Read more...

Hotpoint Washer Appliance Types

Back to Top

Related Hotpoint Washer Parts

Back to Top

Popular Hotpoint Washer Models

Below are the most popular Hotpoint Washer models we have. Enter your model number in the search box to find your model.

Need Help Finding Your Model Number?
View More
Back to Top