Poulan Lawn Tractor Parts
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Poulan Lawn Tractor Parts
Your Price
$6.21
In Stock
Poulan Lawn Tractor Bearing
HINT: I removed the mower deck and placed jack stands under the frame to support the rear end of the mower. I then supported the transaxle with a floor jack. This worked great for positioning/aligning the transaxle up to the frame after the new mounting bracket was installed.
HINT: Due to the shearing of the transaxle mounting bracket, it was difficult to get a socket to seat correctly on the some of the nuts securing the transaxle to the mounting bracket. I highly recommend getting 4 new nuts because you will likely damage/strip the nut while removing it.
HINT: The youtube videos all show removing the rear tires. The rear tires can be difficult to remove; and there are some interesting youtube videos on removing stuck rear tires. If you have a stuck rear tire, you can complete the repair with the tires on; it is just a bit more challenging to squeeze your hands behind the tire to reach the bolts. I was able to only get one tire off.
HINT: If I wasn't able to do the repair with the rear tire on, my idea for getting the rear tire off was to fabricate a bracket that would work with a gear puller. The plan was to utilize the two symmetrical 1/4 inch-ish size holes in the rim to install 12" long bolts. I would then install a C-channel over the bolts, which would place the C-channel directly over the axle. I would then drill a hold in the C-channel for the gear puller bolt to go through. The shoulders of the gear puller bracket would then push against the c-channel. I was planning on using a few large fender washers on the back side of the rim to help prevent the rim from getting damaged when pulling the tire. You will be pulling the rim about 3 inches to get it off the axle.
HINT: It look four hours to repair plus another half hour of watching youtube videos; probably would have taken two hours if I didn't spend two hours trying to take off one of the rear tires that was stuck.
HINT: Since I was working under the mower, I also replaced the drive (motion) belt as preventative maintenance. Read more...
PartSelect Number PS9006914
Manufacturer Part Number 532009040
The OEM bearing, also known as the flange bearing, is silver, made of metal, and sold individually. It is used on riding mowers to secure the wheel in place and allow it to rotate freely on the shaft. Over time, the part may become worn and damaged, which you will notice if you experience a squealing or grinding sound from the wheel in question, or you notice the wheel is sloppy on the shaft.
You will need a hammer and punch to complete this repair, which most of our customers rated as easy. Make sure you tap the new bearing into place evenly inside the tire rim.
Installation Instructions
robert from EUREKA, CA
transaxle rotated forward on 2015 Husqvarna YT42DXLS
2015 Husqvarna YT42DXLS. Both transaxle support struts broke causing the transaxle rotated forward and shear transaxle mounting bracket. The transaxle was not damaged. All 3 parts required replacement. There are some good youtube videos to watch to show how to complete the repair. HINT: I removed the mower deck and placed jack stands under the frame to support the rear end of the mower. I then supported the transaxle with a floor jack. This worked great for positioning/aligning the transaxle up to the frame after the new mounting bracket was installed.
HINT: Due to the shearing of the transaxle mounting bracket, it was difficult to get a socket to seat correctly on the some of the nuts securing the transaxle to the mounting bracket. I highly recommend getting 4 new nuts because you will likely damage/strip the nut while removing it.
HINT: The youtube videos all show removing the rear tires. The rear tires can be difficult to remove; and there are some interesting youtube videos on removing stuck rear tires. If you have a stuck rear tire, you can complete the repair with the tires on; it is just a bit more challenging to squeeze your hands behind the tire to reach the bolts. I was able to only get one tire off.
HINT: If I wasn't able to do the repair with the rear tire on, my idea for getting the rear tire off was to fabricate a bracket that would work with a gear puller. The plan was to utilize the two symmetrical 1/4 inch-ish size holes in the rim to install 12" long bolts. I would then install a C-channel over the bolts, which would place the C-channel directly over the axle. I would then drill a hold in the C-channel for the gear puller bolt to go through. The shoulders of the gear puller bracket would then push against the c-channel. I was planning on using a few large fender washers on the back side of the rim to help prevent the rim from getting damaged when pulling the tire. You will be pulling the rim about 3 inches to get it off the axle.
HINT: It look four hours to repair plus another half hour of watching youtube videos; probably would have taken two hours if I didn't spend two hours trying to take off one of the rear tires that was stuck.
HINT: Since I was working under the mower, I also replaced the drive (motion) belt as preventative maintenance. Read more...
Your Price
$3.99
In Stock
Poulan Lawn Tractor Cap Axle Black 1 50 x 1 00
PartSelect Number PS9007667
Manufacturer Part Number 532104757
This genuine black cap axle, also sometimes known as the dust cap, is around 2 inches in diamater and sold individually. Comprised of plastic, it is designed to keep debris out of the hub and axle of your lawn mower or garden tractor. Over time, your dust cap may become damaged or lost due to wear and tear. If this happens, dirt and debris can freely enter the axle and hub, causing damage.
This is an easy repair to make and does not require any tools. Just look for the cap axle on the rim of the wheel to make your repair.
Installation Instructions
Anthony from OLIVEHILL, TN
Wheel bushings were bad
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.
Read more...
Your Price
$3.99
In Stock
Poulan Lawn Tractor Ring Klip Number T5304-75
PartSelect Number PS9143890
Manufacturer Part Number 812000029
The Ring Klip Number T5304-75, also known simply as a ring clip, is an OEM part designed to secure your mower wheel to its axle.
This part is black, made of metal, and around an inch in length. It is sold individually and may become damaged over time due to wear and fatigue.
Installation Instructions
Anthony from OLIVEHILL, TN
Wheel bushings were bad
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat other side.
Read more...
Your Price
$8.71
In Stock
Poulan Lawn Tractor Bolt and Washer Assembly
PartSelect Number PS9020856
Manufacturer Part Number 532193003
This manufacturer-approved bolt and washer assembly is for lawn tractors.
Wear work gloves to protect your hands when installing this part.
Your Price
$8.27
Special Order
Poulan Lawn Tractor Aluminum Push Rod
PartSelect Number PS9073139
Manufacturer Part Number 690982
This is a replacement push rod for your lawn tractor engine. It is made of aluminum and is the push rod used for the exhaust valve. Occasionally, the push rod in your engine can become damaged, and will need to be replaced before your engine runs at full capacity. This push rod is approximately 6 inches in length, and is an OEM part sourced directly from the manufacturer.
Installation Instructions
Robert from WHITMAN, MA
the head blew a vaulve guide destoying push rods
about 6 hours to tear down and replace don't do it in the hot sun needed more breaks takes longer, but the new factory heads did it started up 185 lbs of compression almost back to new, so much more power than old one's. FYI take off the motor cover every year clean out the debris (grass-mouse nest- and oil) it blocks the air and COOKS THE HEAD it only takes short time and will make that motor last a little longer but it is a BRIGGS engine
Read more...
Your Price
$4.99
In Stock
Poulan Lawn Tractor Plug-Spark
PartSelect Number PS9281094
Manufacturer Part Number 491055S
Installation Instructions
Frederick from BINGHAMTON, NY
Your Price
$3.99
In Stock
Poulan Lawn Tractor Washer 25/32 x 1-1/4 x 16 Ga.
PartSelect Number PS9008998
Manufacturer Part Number 532121749
This OEM washer, also known as a flat washer, has dimensions of 25/32 x 1-1/4. Silver in color and metal, the washer is sold individually. Although this part can have a range of applications depending on the equipment, its general function is to spread the load under a bolt. Ensure you consult your owners manual or check your model number to confirm this is the washer you need for your equipment.
This part will need to be replaced when your existing one is worn or damaged. It is an easy repair according to our customers, and does not require any special tools.
Your Price
$27.50
In Stock
Poulan Lawn Tractor Gear-Governor
PartSelect Number PS9151758
Manufacturer Part Number 793338
Installation Instructions
Robert from WHITMAN, MA
the head blew a vaulve guide destoying push rods
about 6 hours to tear down and replace don't do it in the hot sun needed more breaks takes longer, but the new factory heads did it started up 185 lbs of compression almost back to new, so much more power than old one's. FYI take off the motor cover every year clean out the debris (grass-mouse nest- and oil) it blocks the air and COOKS THE HEAD it only takes short time and will make that motor last a little longer but it is a BRIGGS engine
Read more...
Your Price
$48.56
In Stock
Poulan Lawn Tractor Mandrel Assembly
PartSelect Number PS12087499
Manufacturer Part Number 587819701
Your Price
$3.99
In Stock
Poulan Lawn Tractor Nut, Flange Lock, 5/16-18, Grf
PartSelect Number PS9092936
Manufacturer Part Number 712-04063
This nut is a manufacturer-approved replacement part for various lawn and garden equipment. It is sold individually, not as part of a kit or assembly. Also referred to as a Lock Nut, it is resistant to loosening when threaded on a bolt. It has a variety of applications and is used in multiple locations on most models. Please refer to your owners manual to determine the exact location.
While made of durable metal, the ends can round off from improper use of a wrench or socket. Depending on the location, this part may also become worn through regular use of your machine. It should be replaced when visibly cracked, worn or damaged. To complete this repair, you will need a wrench or socket, and a torque wrench. Ensure you torque the bolt according to the manufacturer recommendations.
Customers rate this repair as Easy.
Installation Instructions
rodney from MUSCATINE, IA
governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions
Read more...
Poulan Lawn Tractor Appliance Types
Related Poulan Lawn Tractor Parts
- Poulan Lawn Tractor Bearings
- Poulan Lawn Tractor Belts
- Poulan Lawn Tractor Blades
- Poulan Lawn Tractor Brackets and Flanges
- Poulan Lawn Tractor Caps and Lids
- Poulan Lawn Tractor Control Cables
- Poulan Lawn Tractor Deflectors and Chutes
- Poulan Lawn Tractor Exhausts
- Poulan Lawn Tractor Filters
- Poulan Lawn Tractor Fuses
- Poulan Lawn Tractor Gears
- Poulan Lawn Tractor Grilles and Kickplates
- Poulan Lawn Tractor Hardware
- Poulan Lawn Tractor Hoses and Tubes
- Poulan Lawn Tractor Ignitions
- Poulan Lawn Tractor Knobs
- Poulan Lawn Tractor Latches
- Poulan Lawn Tractor Lights and Bulbs
- Poulan Lawn Tractor Pulleys
- Poulan Lawn Tractor Seals and Gaskets
- Poulan Lawn Tractor Seats
- Poulan Lawn Tractor Spindles
- Poulan Lawn Tractor Springs and Shock Absorbers
- Poulan Lawn Tractor Starters
- Poulan Lawn Tractor Switches
- Poulan Lawn Tractor Transmissions and Clutches
- Poulan Lawn Tractor Wheels and Rollers
- Poulan Lawn Tractor Wire Plugs and Connectors
Popular Poulan Lawn Tractor Models
Below are the most popular Poulan Lawn Tractor models we have. Enter your model number in the search box to find your model.
- PXT12538 Tractor
- PXT12538 Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Tractor
- PB195H42LT Lawn Mower
- PXT195G42 Lawn Tractor
- PB18542LT Gas Lawn Mower
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
- PB1638LT Lawn Tractor
