Troy-Bilt Generator Parts

Shop By Appliance Type Shop By Part Type

Popular Troy-Bilt Generator Parts

Your Price

$28.63

Troy-Bilt Generator Support-Leg

PartSelect Number PS9940365

Manufacturer Part Number 312510GS

Your Price

$45.30

Troy-Bilt Generator Cap, Fuel Gauge

★★★★★

2 Reviews

PartSelect Number PS9314364

Manufacturer Part Number B4363GS

This OEM replacement fuel gauge cap is designed for use in generators. It comes in a cylindrical shape and has a built-in window to easily view the fuel levels without pulling out the entire cap. It is approximately 5.25 inches in length, while the head has a diameter of 3 inches. The purpose of the cap is to cover and protect the fuel gauge, which indicates the levels of gas available in the tank. It prevents dirt and debris from entering the gauge area and prevents fuel from leaking out. A faulty cap will allow contaminants to enter the gauge, and cause fuel to leak, leading to inaccurate fuel readings and safety risks. Twist the cap to remove it and clean the surrounding area thoroughly. Place the new gauge cap in position and ensure that it is locked in place.

Your Price

$5.19

Troy-Bilt Generator Grommet,Tank

PartSelect Number PS9307985

Manufacturer Part Number 83465GS

Fuel Valve W/Bushing – Part Number: 192980GS

Your Price

$19.31

Troy-Bilt Generator Fuel Valve W/Bushing

★★★★★

5 Reviews

PartSelect Number PS8911051

Manufacturer Part Number 192980GS

Made of durable rubber and plastic components, this Fuel Valve and Bushing are designed for use in over 150 models of generators and pressure washers. This item is sold as a kit, including the valve and the rubber cap. Its primary purpose is to deliver fuel from the tank to the carburetor. This part is found on the underside of the fuel tank and should be replaced when it is worn or damaged. When malfunctioning, it may cause your engine to be starved of fuel and run rough or not at all. You will need a screwdriver and pliers to complete this repair. Customers rate this repair as Easy.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Bruce from CARNATION, WA

Wouldn’t start.

I installed a new solenoid starter. Took me a total of 20 minutes. Started right up. Read more...

Your Price

$34.68

Troy-Bilt Generator Solenoid-Starter

★★★★★

3 Reviews

PartSelect Number PS9064363

Manufacturer Part Number 691656

A starter solenoid, also known as a starter relay, is an electrical component that is used within small engine systems to control the starter motor by engaging it when an ignition key is turned - acting as a bridge between the battery and starter motor. This starter solenoid is designed for use with various models of lawn mower and other small engine equipment and is sold as an individual part with no securing hardware. Depending on your model and type of equipment, the location of the starter solenoid may be different, but it is typically located on or around the engine block, and close to the battery. If you notice issues with starting your equipment such as clicking sounds, intermittent starting or simply not starting at all, the solenoid may be burnt or damaged and need replacement immediately. You can test the solenoid for continuity on its terminals with a multimeter, but make sure to take safety precautions. To replace a starter solenoid, you need only disconnect the equipment from power, locate the solenoid, disconnect and remove any connections and securing bolts before you can replace it and test for full functionality.

Installation Instructions

James from PICAYUNE, MS

Dry rotted rubber

Put some dish soap on the rubber, push into the tank hole, slip 1x2 into the handle of the tank and over the new part and pry down pushing it into the hole. Took about 2 minutes. Read more...