Official Whirlpool Ice Maker Parts

Videos!

Refrigerator Door Switch – Part Number: W11384469

Your Price

$38.48

Whirlpool Ice Maker Refrigerator Door Switch

★★★★★

83 Reviews

PartSelect Number PS12728638

Manufacturer Part Number W11384469

Door switch turns the light off when you close the door.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Clint from Rayville, MO

Lights inside refrigerator not working

I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. Read more...

Refrigerator Water Filter – Part Number: F2WC9I1

Your Price

$75.60

Whirlpool Ice Maker Refrigerator Water Filter

★★★★★

8 Reviews

PartSelect Number PS8759230

Manufacturer Part Number F2WC9I1

This genuine OEM replacement part is a water filter for your fridge or freestanding ice maker. The filter is used to remove contaminants and particles from the water, to ensure a clean and fresh taste. The filter should be replaced every six to nine months, or after 2000 gallons of water have passed through, whichever occurs first.

Videos!

Your Price

$127.17

Whirlpool Ice Maker ICEMAKER

★★★★★

25 Reviews

PartSelect Number PS16660327

Manufacturer Part Number W11510803

This genuine OEM ice maker kit is designed to fit refrigerators that did not originally come with an ice maker. This kit contains everything needed to install the new ice maker on your refrigerator including: the ice maker, ice bin, inlet valve, fill tube, and hardware. If your new ice maker does not function properly after being installed, check the freezer temperature. The freezer must to be around zero degrees Fahrenheit. Remember to disconnect the power and water supply to your refrigerator before beginning this installation. Make sure to check that your model is compatible with this part before ordering. Note: The manufacturer has updated this part. It may differ in appearance but will function the same as the original.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

Donald A. from ORLANDO, FL

Wanted to install ice maker in my freezer

I was clening my uprght freezer and noticed that it was preped for an icemaker. I first went to the Whilpool website and could not find my part as my freezer was a 2008 model.

I saw PartSelect on the search page and went to thier site.
I put in my modle number of the Whilpool Ice maker kit that was on the back of my freezer. PartSelect had the part in stock and approx $18.00 less than the other kits listed on the Whilpool site (that did not match my kit number). I orderd the kit on Sunday and it arrived on Wednesday. It took less than and hour to install. Every part I needed was included. The following day I installed the water line and now I have an extra icemaker. Read more...

Ice Maker Bin Temperature Sensor – Part Number: WPW10511923

Your Price

$73.64

Whirlpool Ice Maker Bin Temperature Sensor

★★★★★

13 Reviews

PartSelect Number PS11755842

Manufacturer Part Number WPW10511923

This bin temperature sensor is for ice makers. The bin temperature sensor monitors the temperature in the ice maker bin and sends the temperature reading to the electronic control board. Disconnect the power before installing this part. Wear work gloves to protect your hands.

Installation Instructions

Travis from N CHESTERFLD, VA

Ice bin overfilling

I'm an hvac/r technician, and regularly work on ice machines. Begin my pulling the white over beneath the control panel. It snaps in place so pull on the bottom then left out. 1/4 nut driver is all you need, and remove the screw holding the bin thermistor clip to the side. Up to the right , beneath the control panel, behind the plastic panel you previously removed is the mollex connector. Unplug the thermistor and follow instructions in reverse to reinstall. Read more...

Touch-Up Paint - White – Part Number: 72017

Your Price

$8.00

Whirlpool Ice Maker Touch-Up Paint - White

★★★★★

1 Review

PartSelect Number PS385132

Manufacturer Part Number 72017

This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is an 18 ml, or.6 fluid ounces, bottle of touch-up paint. It also features a brush for easy application. This quick-drying, long-lasting paint is perfect for fixing any nicks, scratches, or chips on the exterior of your appliance. This paint is white in color, and provides a durable finish.

Installation Instructions

Michelle from Richardson, TX

Scratches in Surface

This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. Read more...

Videos!

Condenser Fan Motor Kit – Part Number: W10124096

Your Price

$127.54

Whirlpool Ice Maker Condenser Fan Motor Kit

★★★★★

44 Reviews

PartSelect Number PS1957416

Manufacturer Part Number W10124096

This condenser fan motor kit includes a motor, fan blade, wire harness, and screws. Used in a refrigerator, the condenser fan motor moves the condenser fan blade to direct and move air across the condenser coil. Please note: The manufacturer has changed the appearance of the product from the original. The kit still functions the same as the original part. It is an OEM factory replacement. Make sure to unplug the refrigerator from the power source and wear gloves to protect your hands. Also, a helpful tip is to store food to prevent deterioration when the power is off.

Fixes these symptoms

Clicking sound
Freezer section too warm
Fridge and Freezer are too warm
See more...

Installation Instructions

Josue from Jacksonville, NC

Seven year old condenser fan was making noise when it was running.

The process to repair was very simple, I removed the back of the refrigerator to expose the motor area. I then removed three screws that held the condenser motor in place. once it was loose I detactched the electrical harness and removed the old motor. I then placed the new motor in place and secured it with the screws and reattached the new electrical harness that came with the new part. Once completed I reviewed it to make sure I didn't miss anything. I then replaced the cover over the motor area and enjoyed my success in repairing my own appliance with no added cost for labor, which would have been expensive I'm sure. The part purchased came with clear and consice instructions very easy to follow. Read more...

Refrigerator Single Water Inlet Valve – Part Number: WP2315576

Your Price

$71.47

Whirlpool Ice Maker Refrigerator Single Water Inlet Valve

★★★★★

23 Reviews

PartSelect Number PS11740365

Manufacturer Part Number WP2315576

The single water inlet valve, also known as a water solenoid valve, is used for refrigerators. This part is a solenoid-operated switch that releases water from the supply line to the water valve and into the icemaker mold when activated. If your icemaker is making small cubes, does not dispense ice or water, or leaks, this replacement could solve the issue. The tools needed for this repair are a 1/4 inch nut driver and a utility knife. Refer to the diagram provided by the manufacturer for further instructions. As a safety precaution, remember to unplug your dryer from the power source.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

Robert from Abingdon, MD

No water feed to icemaker

To troubleshoot - Check water supply to valve. It f that's good - remove back plate, remove water valve reconnect inlet line, disconnect electrical connector, place valve over a pan with outlet fitting disconnected, temporarily connect 110 VAC with clipleads to water valve solenoid. No water flow means valve is not opening. To install new valve, connect outlet line, and wiring connector, then insert in cabinet and install 2 screws, reinstall back plate, connect water inlet line. Read more...

Your Price

$67.84

Whirlpool Ice Maker PUMP

★★★★★

6 Reviews

PartSelect Number PS16730541

Manufacturer Part Number W11566405

A recirculating pump is used with standalone ice cube makers. It circulates the water over the top of the evaporator plate, which produces a layer of ice that is then broken down into ice cubes. If you notice that your ice maker is no longer producing ice or there is no water flowing over the cooling plate, this could be due to the recirculating pump not working. Be sure to keep the pump clean and free of build-up. This pump is 5.75 inches in length, 4.75 inches in width, 4.25 inches in height and weighs 0.81 lbs. This is a genuine OEM appliance part that comes directly from the manufacturer.

Installation Instructions

Richard from North Wilkesboro, NC

was not making ice

diagnosed no water flow over evaporator checked voltage into pump then checked pump with ohm meter ordered pump and installed by removing access cover and water holding assembly installed new pump replaced water holding assembly and access cover and returned icemaker to service all is well Read more...

Videos!

Door Light Switch – Part Number: WP2149705

Your Price

$30.34

Whirlpool Ice Maker Door Light Switch

★★★★★

14 Reviews

PartSelect Number PS11738900

Manufacturer Part Number WP2149705

The purpose of the light switch in your refrigerator is to automatically turn on the light when the door is opened. If the light does not come on automatically when you open the door, the contacts inside the light switch may be burned out, meaning it is time to replace the switch. This package contains both the new light switch and a small plastic spacer. To complete this repair, you will need to remove the control panel section of your refrigerator. The only tools you will require for this repair are a 1/4-inch nut driver and maybe a small flat blade screwdriver. Be sure to disconnect the power source from the refrigerator before completing this repair.

Fixes these symptoms

Light not working
See more...

Installation Instructions

Randy from Hays, KS

Broken light switch

Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the back with large washers on them that hold the back to the top of the box that go in vertically.The switch was a snap ( make that two snaps ) the wiring is almost self explanatory. then it gos back to the way you took it off. OH! and don't forget to turn the light bulb all the way back in to the socket , so the light will work after you take the time to install it yourself.I had the water supply line from under the box to the water dispenser in the door and the total bill on that was one hundred thirty seven and a hand full of change.Don't be afraid to do it yourself the savings is enough on one one item to make several months payments on a new one Randy the "Handy Man' Read more...